Woodworking Woodworking Basics

Stacked Dado Blade Sets

Closeup of circular saw blade

Ibrahim Kass / Getty Images

Many woodworking projects call for dadoes or rabbets. Years ago, these would have most likely been cut using a specialty plane or by hand with a chisel. These days, with all of the manufactured wood products and power tools, these methods would be considered nostalgic. A more modern method for cutting these joints would be with a dado blade on your table saw or radial-arm saw.

Styles

There are two types of dado blades:

  • Stacked dado blade set
  • Wobble dado blade
Illustration of stacked and wobble dado blades
Illustration: The Spruce / Chloe Giroux

The stacked dado set is typically considered the better option for a number of reasons. First of all, a stacked dado set consists of two saw blades and a number of "chippers" that fit between the two blades on the saw's arbor. The width of the dado is determined by the number of chippers installed between the inner and outer saw blade.

By contrast, a wobble dado blade is a single blade that has a collar that allows the blade to be set up at various angles. The blade then "wobbles" as it cuts. The steeper the angle, the wider the cut.

Setup

The instructions that accompany your stacked dado will go into detail as to the configurations necessary to create cuts of various widths. However, most sets contain four 1/8-inch wide kerf chippers and a single 1/16-inch chipper. The inner and outer blades each have a 1/8-inch kerf as well. Since the set cannot be used without the inner and outer blades, the minimum cut width would be 1/4 inch.

The basic configuration of chippers for sizes should set up as per the following chart:

  • 1/4-inch cut: Inner and outer blades only.
  • 5/16-inch cut: Add only the 1/16-inch chipper between the blades.
  • 3/8-inch cut: Add only one 1/8-inch chipper.
  • 7/16-inch cut: Add one 1/8-inch and one 1/16-inch chipper.
  • 1/2-inch cut: Add two 1/8-inch chippers.
  • 9/16-inch cut: Add two 1/8-inch and one 1/16-inch chipper.
  • 5/8-inch cut: Add three 1/8-inch chippers.
  • 11/16-inch cut: Add three 1/8-inch and one 1/16-inch chipper.
  • 3/4-inch cut: Add four 1/8-inch chippers.
  • 13/16-inch cut: Add four 1/8-inch and one 1/16-inch chipper.

Safe Usage

When positioning your stacked dado set onto your saw's arbor, always make sure that the arbor is long enough to accommodate the blades you're adding. In other words, there needs to be enough arbor length that the arbor nut is fully threaded onto the arbor when tightened against the blade.

Also, when using a stacked dado blade on a table saw, be certain that you use a dado throat plate or make one specifically for the task out of plywood. Never attempt to use a dado blade with the throat plate removed.

Finally, never attempt to use a stacked dado—or wobble dado, for that matter—with a circular saw. This simply isn't safe, as these are designed for use with a radial arm or table saw only.

Additional Configurations

In addition to the two blades and the chippers, your set will likely also include some spacers that look like thin washers. These spacers can be used in between the blades and chippers to add a little additional width. This is especially handy when cutting dadoes or rabbets for plywood, which typically has widths such as 15/32 inch or 23/32 inch.